FREE DELIVERY AUSTRALIA WIDE
Type push in quick connect cables – minimal tools required. Cable connects via a quick connect hand pin that is easy to remove and replace.
A Planetary Gear Design has three satellite gears that rotate on their axis and at the same time rotate around the central helm axis. This allows for equal distribution of engine torque over three points of the central gear, dividing and balancing the system loads. The benefits of this special design are increased system longevity, increased efficiency and less engine feed Return compared to single pinion gear helms.
This Planetary Gear Helm Steering System Kits offers fast connection and simple installation, with all stainless steel cable output ends as per safety standards.
Made with corrosion resistant materials. Particularly suitable where clearance is limited. Standard 3/4” tapered shaft, and optional 20° bezel kit. Steering wheel turns approximately 3.8x lock to lock.
The steering system is not to be used on boats equipped with engines that exceed the maximum horsepower rating of the boat.
The Kit Includes:
· Steering Cable 6ft up to 25ft
· Steering Helm - Planetary gear, 3/4“” tapered shaft
· Bezel Kit
· Plastic Steering Wheel
· 90 degree bearing
1. Designed and developed especially for marine use.
2. Mainly applied in mechanical/manual steering for yachts, fishing boats and other waterborne vehicles.
3. Made in zinc alloy, corrosion resistant, ergonomically designed, easy to install, compact for mounting.
4. Combined with steering cable, 316 stainless steel end fittings, can be any length within 30 Feet.
(Suits T71FC optional Bezel kit 20 degrees see other)
The Steering Helm is a gearbox arrangement mounted on the dashboard of the boat.On the shaft of the helm is mounted the Steering Wheel.
Suit for max. 30 Feet(9 meters) out board boat(up to 200hp)
Max load 300 pounds at tiller.
Planetary Gear design:3 turns lock to lock
Max steering wheel dia 406mm (16")
Shaft Length: 127mm
Material:Chromed plated Zinc Alloy
Bezel kit is a plastic part along with related hardware which is mounted between the steering wheel and dash board to cover the helm hardware.
Bezel made from Engineering Plastic
Black color available as standard options
90 degree tilt
Contains mounting hardware
The Steering Cable is a push pull mechanical cable which convents the rotary motion of the helm to linear motion at the engine/rudder.One end of the cable is connected to the helm & the end to the rudder.The latest construction technology, the internal control line used elastic material.Output used 304 stainless steel seamless pipe and corrosion-resistant materials, control lines has longer life.
5-30 feet length control line can be used, and to increase per 1-foot increments.
Output ends made of 316 Stainless Steel
Minimum bend radius:8 inch (200mm)
Maximum working load at Tiller end:5000N
Cable Outer Diameter:16.5mm
Spiral inner cable Diameter:8mm